When is it recommended to straighten sheet metal with a vacuum?
If you have a large uniform dent on your car, which was caused by a single mild impact, vacuum body repair is the solution for you. Indentations can be found on a flat place and also on a place where some are curved, moldings, etc. It can be placed on a flat surface such as the hood, roof, door, etc. Fixing it should be easy. It is best to use a vacuum rubber, which should be moistened as well as the curved surface of the sheet metal on the car due to the better fit of the vacuum rubber. Place the vacuum rubber on the crooked part of the sheet and pull it, when you hear the sheet crack, it should be finished, ie. that the sheet is back in place and that”s it.
Why straightening sheet metal with a vacuum?
Vacuum repair of bodywork is a very effective method of correcting dents on car bodywork. It is recommended that the dents be repaired as soon as possible due to the deformation, so that after the repair it can be returned to its previous state. The surface we are correcting must be clean. A rubber vacuum is used, which gets wet as well as the place we are correcting gets wet, due to a better grip of the vacuum and less damage to the sheet metal. There are tools that have a built-in rod that has some kind of hammer to hit after the vacuum is caught. Punching serves to return the sheet to its proper position.
What are the ways to straighten sheet metal with a vacuum?
Vacuum straightening of sheet metal You can try correcting the sheet metal with a vacuum and try to restore the sheet with a regular vacuum and a sudden pull, by placing a wet rubber vacuum in the center of the dent and pulling it until the vacuum loosens or straightens. Silicone vacuums give better results than rubber vacuums. The pulling force is better managed with the silicone vacuum because they are more elastic and it is better to see where the yield point of the vacuum is. If this does not give results, you can lubricate the vacuum and circulate the tensioned vacuum around the edges of the dent and thus gradually correct the dent. In terms of speed and success, this system gives the best results, you just have to make sure that the surfaces are cleaned, otherwise the paint will be damaged. If the paint is damaged due to the vacuum cycle, it can be easily repaired by polishing. This method can be used to correct damages on or in the grooves, even on the edges – edges, etc. It is only necessary to use a vacuum to start from a flat surface and drag it to the desired place, since the silicone vacuum is more flexible and follows the depressions better.
Is it safe to vacuum repair sheet metal?
When it comes to auto bodywork, vacuum straightening of bodywork is done without any damage to the paint and varnish. This technique is becoming more and more popular in the world, and in almost 90% of cases, it is fine and precise sheet metal work, which offers a complete straightening of the sheet metal, to the point where it is unrecognizable that there was ever a dent. For a complete treatment, you can paint the bodywork and the car in a special chamber, equipped with adequate equipment. Make your four-wheeler equal to all those cars that have just left the showrooms.
What is vacuum straightening?
Vacuum repair of bodywork is the correction of mechanical damage to car bodywork caused by hail, as well as other major damage. Vacuum repair of auto bodywork, also known as “massage”, is a method of correcting damaged bodywork using glue and vacuum. The advantage over the previous methods is that the paint does not come off and there is no need for repainting. In addition, the works are performed in a much shorter period of time, so the time saving is great.
How much does it cost to straighten sheet metal with a vacuum?
Repairing the sheet metal with a vacuum can cost very little, from €20, if the damage is minor. On the other hand, classic straightening and coloring methods can cost significantly more. In order to get more precise information about how much it will cost to repair your car, post the required service on bellcom.rs. Remember to post as many photos of the damage as possible to get the most accurate quotes. Choose the best offer from local services/handymen.
