What is a fuse box?
The fuse box in your home exists to protect against power surges and potentially dangerous fires. When an overload occurs in the system caused by a short circuit or other fault, the fuse will interrupt the circuit instead of allowing the current to continue its path to the electrical device. When a fuse blows, it cuts off the power to that part. Installing a fuse box is something that should only be done if you are an expert in the field.
What should be done before installing the fuse box?
Fuse box Before you buy a new fuse box, you will need to determine the actual load of electricity required for your home. To figure this out, work with an electrician or a company in the field. It is important to know this number because there are different fuse boxes that you can buy. Once you know the amount of insurance needed for your home, add an additional amount for future expenses. You may also find fuse information on your old box if it is not too old. Then buy the correct fuses. Knowing your current and future amperage, an electrician will help you choose the correct fuse box. Choose the right box based on need, not cost.
Remove the old fuse box
To begin wiring the new fuse box, first make sure the power is off. Disconnect the power from the current meter so there are no surprises. Check all rooms to make sure the power is definitely off. Remove all fuses in the current box. This will not only make the case lighter when removing it, but will ensure that you won”t have the problem of broken fuses if you drop it. After removing the fuses, you will see that there are several wires that connect to each of the terminals. Use a screwdriver and loosen the fixing screw of each one. Remove each wire and label them so you know where to connect in the new box. Use duct tape and wrap it around the wire. Use a screwdriver and remove the fuse panel from its place on the wall. Make sure there is no moisture or any other type of damage behind it.
Connect the new fuse box
Place the new fuse box in place and secure it to the wall. To connect to their individual terminals, use the same wires that you removed from the old box. Read each label and carefully wrap the exposed wire onto the retaining screw. Tighten the screw and be careful not to puncture the wires or break any ends. To complete the wiring of the fuse box, install new fuses and connect the mains. Check each fuse to ensure proper operation.
What should you pay attention to when replacing the fuse box?
It is very important to note that private individuals are generally prohibited from working on the fuse box. In addition, all electrical box cables must be properly connected. Acceptance of all protective measures can only be performed by a master electrician. In addition, certain regulations must be observed, for example the fuse box must be placed on a flat surface and at a prescribed distance from walls and ceilings. To replace the fuse box, we recommend that you post the required service on bellcom.rs. You will receive offers from different craftsmen/companies, and it is up to you to choose the offer that suits you best.
How much does it cost to replace a fuse box?
Material costs are at least €100, and installation by experts costs from €100 and up.
